Printable protractor (180° and 360°)
A protractor of 90 mm radius fits on Letter or A4 with its 1° marks 1.57 mm apart at the edge; set any radius up to the sheet's limit, half or full circle. Angles do not depend on the print scale, so a protractor reads true even if the printer shrank it, but the radius does: check the 100 mm bar if you also measure lengths from it.
Up to 124 mm fits on Letter (4.88 in)
Half circle, 0–180° both ways: 1° marks, longer every 5° and 10°.
- Radius
- 90 mm (3.54 in)
- 1° marks apart at the edge
- 1.57 mm
How it is calculated
- Distance between 1° marks = radius × π ÷ 180 = 90 × 3.1416 ÷ 180 = 1.57 mm.
- Angles read true at any print scale; the radius matches only at 100%.
Measure the bar at the foot of the printout
True to size: the printer kept 100% within half a millimeter.
Protractor on screen
Drag across the protractor, or use the arrow keys, to turn the arm. Angles do not depend on the screen size, so it needs no calibration.
How to measure an angle
Put the center mark on the corner of the angle and lay the baseline along one side.
Follow the other side out to the scale. Read the scale whose 0 sits on the first side: the outer numbers count from the left, the inner from the right.
To draw an angle, mark the degree you want at the edge, remove the protractor and join the mark to the corner.
Print it so it lasts
On clear film or tracing paper you see the work through the protractor. On card stock it lasts longer; cut along the arc and the baseline.
A larger radius spreads the 1° marks apart: at 90 mm radius they are 1.57 mm apart at the edge.
How do you find the measure of an angle with a protractor?
To measure an angle with a protractor, put the center mark on the corner, baseline along one side, then read where the other side crosses the scale that starts at 0 on the baseline side.
Can I use a protractor online?
Yes, the online protractor on this page turns with the pointer and shows the angle. Angles are the same at any screen size, so it needs no calibration.
How do I print a 360 degree protractor?
To print a 360 degree protractor, choose Full circle. On Letter or A4 the largest full circle that fits inside the margins and above the check bars is shown in the radius box.
How do I print a protractor at actual size?
To print a protractor at actual size, print at 100% (Actual size) and measure the 100 mm bar. Angles read true at any scale; the radius only matches when the bar does.
Ready-made PDFs: Letter, A4. Free to print, copy and share under CC0. Sizes of the paper are the published figures of the documents below.