1-1/2 inch NPT thread size

1-1/2 inch NPT has 11.5 threads per inch (a pitch of 0.087 in) and an outside diameter of 1.900 in (48.3 mm). Drill a 1-23/32 in (1.7188 in) hole before tapping it without a reamer. The thread is cut on 1-1/2 inch pipe, so the outside diameter of the thread is the outside diameter of the pipe, not 1-1/2 inch.

SIDE VIEW, NOT TO SCALEpitch 0.087 inOD 1.900 in48.3 mm1-1/2 in NPT · 11.5 threads per inchtap drill 1-23/32 in · thread narrows toward the pipe end

1-1/2 inch NPT dimensions

1-1/2 inch NPT thread as published in the documents below; pitch and millimeters are calculated
Threads per inch11.5
Pitch (1 ÷ threads per inch)0.087 in (2.209 mm)
Outside diameter of the thread1.900 in (48.3 mm)
Tap drill, tapping without a reamer1-23/32 in (1.7188 in, 43.66 mm)

How to measure a 1-1/2″ NPT thread

On a male thread, measure the outside diameter across the crests near the pipe end with calipers: about 1.900 in (48.3 mm) is 1-1/2 inch NPT. Count the threads in one inch with a thread gauge or a ruler: 1-1/2 inch has 11.5. On a female thread, the opening is a little smaller than the outside diameter of the male thread because the thread is tapered. The pipe size identifier also matches thread measurements.

NPT sizes next to 1-1/2 inch

NPT one size down, this size and one size up: threads per inch, outside diameter of the thread and tap drill (tapping without a reamer)
Nominal sizeThreads per inchThread OD, inTap drill
1-1/4″11.51.6601-31/64
1-1/2″ (this page)11.51.9001-23/32
2″11.52.3752-3/16

Which pipe takes a 1-1/2″ NPT thread

1-1/2 inch NPT is cut on 1-1/2 inch steel pipe, 1.900 in outside. The thread takes part of the wall, so the wall of the pipe matters: Schedule 40 has a 0.145 in wall and Schedule 80 has a 0.200 in wall. See 1-1/2 inch steel pipe dimensions.