NPT pipe thread chart
1/2 inch NPT has 14 threads per inch and a 0.840 in (21.3 mm) outside diameter, and takes a 45/64 in tap drill (tapping without a reamer). NPT sizes from 1/8 to 4 inch use 5 thread counts (27, 18, 14, 11.5, 8 per inch); the outside diameter of the thread is the outside diameter of the pipe of the same nominal size.
| Nominal size | Threads per inch | Pitch, in | Thread OD, in | Thread OD, mm | Tap drill, no reamer | Tap drill, in |
|---|---|---|---|---|---|---|
| 1/8″ | 27 | 0.037 | 0.405 | 10.3 | — | — |
| 1/4″ | 18 | 0.0556 | 0.540 | 13.7 | 7/16 | 0.4375 |
| 3/8″ | 18 | 0.0556 | 0.675 | 17.1 | 9/16 | 0.5625 |
| 1/2″ | 14 | 0.0714 | 0.840 | 21.3 | 45/64 | 0.7031 |
| 3/4″ | 14 | 0.0714 | 1.050 | 26.7 | 29/32 | 0.9063 |
| 1″ | 11.5 | 0.087 | 1.315 | 33.4 | 1-9/64 | 1.1406 |
| 1-1/4″ | 11.5 | 0.087 | 1.660 | 42.2 | 1-31/64 | 1.4844 |
| 1-1/2″ | 11.5 | 0.087 | 1.900 | 48.3 | 1-23/32 | 1.7188 |
| 2″ | 11.5 | 0.087 | 2.375 | 60.3 | 2-3/16 | 2.1875 |
| 2-1/2″ | 8 | 0.125 | 2.875 | 73.0 | — | — |
| 3″ | 8 | 0.125 | 3.500 | 88.9 | — | — |
| 3-1/2″ | 8 | 0.125 | 4.000 | 101.6 | — | — |
| 4″ | 8 | 0.125 | 4.500 | 114.3 | — | — |
How to identify an NPT thread
Measure the outside diameter of a male thread across the crests with calipers and count the threads in one inch with a thread gauge or a ruler, then find both in the chart. A 1/2 inch NPT thread measures about 0.840 in, not 1/2 in, because the nominal size names the pipe, not the thread. A female thread opening reads a little smaller than the male thread, as the thread is tapered. The pipe size identifier matches a thread measurement for you.
Pitch is 1 ÷ threads per inch: 0.0714 in for 1/2 inch (1.814 mm). NPT is cut on steel pipe; see 1/2 inch steel pipe dimensions for the pipe itself.