1/2 inch NPT thread size

1/2 inch NPT has 14 threads per inch (a pitch of 0.0714 in) and an outside diameter of 0.840 in (21.3 mm). Drill a 45/64 in (0.7031 in) hole before tapping it without a reamer. The thread is cut on 1/2 inch pipe, so the outside diameter of the thread is the outside diameter of the pipe, not 1/2 inch.

SIDE VIEW, NOT TO SCALEpitch 0.0714 inOD 0.840 in21.3 mm1/2 in NPT · 14 threads per inchtap drill 45/64 in · thread narrows toward the pipe end

1/2 inch NPT dimensions

1/2 inch NPT thread as published in the documents below; pitch and millimeters are calculated
Threads per inch14
Pitch (1 ÷ threads per inch)0.0714 in (1.814 mm)
Outside diameter of the thread0.840 in (21.3 mm)
Tap drill, tapping without a reamer45/64 in (0.7031 in, 17.86 mm)

How to measure a 1/2″ NPT thread

On a male thread, measure the outside diameter across the crests near the pipe end with calipers: about 0.840 in (21.3 mm) is 1/2 inch NPT. Count the threads in one inch with a thread gauge or a ruler: 1/2 inch has 14. On a female thread, the opening is a little smaller than the outside diameter of the male thread because the thread is tapered. The pipe size identifier also matches thread measurements.

NPT sizes next to 1/2 inch

NPT one size down, this size and one size up: threads per inch, outside diameter of the thread and tap drill (tapping without a reamer)
Nominal sizeThreads per inchThread OD, inTap drill
3/8″180.6759/16
1/2″ (this page)140.84045/64
3/4″141.05029/32

Which pipe takes a 1/2″ NPT thread

1/2 inch NPT is cut on 1/2 inch steel pipe, 0.840 in outside. The thread takes part of the wall, so the wall of the pipe matters: Schedule 40 has a 0.109 in wall and Schedule 80 has a 0.147 in wall. See 1/2 inch steel pipe dimensions.