3/4 inch NPT thread size

3/4 inch NPT has 14 threads per inch (a pitch of 0.0714 in) and an outside diameter of 1.050 in (26.7 mm). Drill a 29/32 in (0.9063 in) hole before tapping it without a reamer. The thread is cut on 3/4 inch pipe, so the outside diameter of the thread is the outside diameter of the pipe, not 3/4 inch.

SIDE VIEW, NOT TO SCALEpitch 0.0714 inOD 1.050 in26.7 mm3/4 in NPT · 14 threads per inchtap drill 29/32 in · thread narrows toward the pipe end

3/4 inch NPT dimensions

3/4 inch NPT thread as published in the documents below; pitch and millimeters are calculated
Threads per inch14
Pitch (1 ÷ threads per inch)0.0714 in (1.814 mm)
Outside diameter of the thread1.050 in (26.7 mm)
Tap drill, tapping without a reamer29/32 in (0.9063 in, 23.02 mm)

How to measure a 3/4″ NPT thread

On a male thread, measure the outside diameter across the crests near the pipe end with calipers: about 1.050 in (26.7 mm) is 3/4 inch NPT. Count the threads in one inch with a thread gauge or a ruler: 3/4 inch has 14. On a female thread, the opening is a little smaller than the outside diameter of the male thread because the thread is tapered. The pipe size identifier also matches thread measurements.

NPT sizes next to 3/4 inch

NPT one size down, this size and one size up: threads per inch, outside diameter of the thread and tap drill (tapping without a reamer)
Nominal sizeThreads per inchThread OD, inTap drill
1/2″140.84045/64
3/4″ (this page)141.05029/32
1″11.51.3151-9/64

Which pipe takes a 3/4″ NPT thread

3/4 inch NPT is cut on 3/4 inch steel pipe, 1.050 in outside. The thread takes part of the wall, so the wall of the pipe matters: Schedule 40 has a 0.113 in wall and Schedule 80 has a 0.154 in wall. See 3/4 inch steel pipe dimensions.